37dBm gsm900 1800 2100 triple band 2g 3g Band Selective Repeaters -Tri-band Repeater

37dBm gsm900 1800 2100 triple band 2g 3g Band Selective Repeaters

PRODUCT NAME :	37dBm gsm900 1800 2100 triple band 2g 3g Band Selective Repeaters
MODEL :	KT-G/D/WRP-B25/75/60-P37-B
PRODUCT CATEGORY :	Tri-band Repeater
POWER SUPPLY :	AC 110V、AC 220V、DC -48V
FREQUENCY :	890-915MHz/935-960MHz、1710-1785MHz/1805-1880MHz、1920-1980MHz/2110~2170MHz
SCENARIOS :	Stadium、Office、Highway、Railway、Scenic、Pier、Island、Offshore、Urban road、Supermarket 、Metro、Rural、Suburban、Hospital、Campus、Mine、Oilfield、Tunnel
COVERAGE :	5000sqm、1-3km、1-5KM、5000-50000sqm

Introduction
Mainfeature
Application&scenarios
Specification
Parts/Warranty

37dbm GSM900/DCS1800/WCDMA2100 5W tri band Band Selective Repeaters（KT-G/D/WRP-B25/75/60-P37-B）

Repeater

In telecommunications, a repeater is an electronic device that receives a signal and retransmits it. Repeaters are used to extend transmissions so that the signal can cover longer distances or be received on the other side of an obstruction.
There are several different types of repeaters; a telephone repeater is an amplifier in a telephone line, an optical repeater is an optoelectronic circuit that amplifies the light beam in an optical fiber cable; and a radio repeater is a radio receiver and transmitter that retransmits a radio signal.

Kingtone Repeaters

Kingtone system is designed to solve problems of weak mobile signal, which is much cheaper than adding a new Base Station (BTS). Main operation of RF Repeaters system is to receive low‐power signal from BTS via radio frequency transmission and then transmit the amplified signal to the areas where network coverage is inadequate. And the mobile signal is also amplified and transmitted to the BTS via the opposite direction.

Telephone repeater
This is used to increase the range of telephone signals in a telephone line. They are most frequently used in trunklines that carry long distance calls. In an analog telephone line consisting of a pair of wires, it consists of an amplifier circuit made of transistors which use power from a DC current source to increase the power of the alternating current audio signal on the line. Since the telephone is a duplex (bidirectional) communication system, the wire pair carries two audio signals, one going in each direction. So telephone repeaters have to be bilateral, amplifying the signal in both directions without causing feedback, which complicates their design considerably. Telephone repeaters were the first type of repeater and were some of the first applications of amplification. The development of telephone repeaters between 1900 and 1915 made long distance phone service possible. However most telecommunications cables are now fiber optic cables which use optical repeaters (below).

Cellular repeater

This is a radio repeater for boosting cell phone reception in a limited area. The device functions like a small cellular base station, with a directional antenna to receive the signal from the nearest cell tower, an amplifier, and a local antenna to rebroadcast the signal to nearby cell phones. It is often used in downtown office buildings.

Main Features of kingtone cellular repeater
◇ High linearity PA; High system gain；
◇ Intelligent ALC technology；
◇ Full duplex and high isolation from uplink to downlink；
◇ Automatic Operation convenient operation；
◇ Integrated technique with reliable performance;
◇ Bandwidth can be configured from 5-25MHz in work band.
◇ Local and remote monitoring (optional) with automatic fault alarm &remote control;
◇ Weatherproof design for all-weather installation;

Technical Specifications

Items			Testing Condition	Specification
				Uplink	Downlink
Working Frequency(MHz)			Nominal Frequency	890 – 915MHz	935 - 960MHz
				1710 - 1785MHz	1805 - 1880MHz
				1920 – 1980MHz	2110 – 2170MHz
Gain(dB)			Nominal Output Power-5dB	Max.90±3
Output Power (dBm)			WCDMA modulating signal	33	37
ALC (dBm)			Input Signal add 20dB	△Po≤±1
Noise Figure (dB)			Working in-band（Max. Gain）	≤5
Ripple in-band (dB)			Nominal Output Power -5dB	≤3
Frequency Tolerance (ppm)			Nominal Output Power	≤0.05
Time Delay (us)			Working in-band	≤5
EVM(%)			Working in-band	≤12.5
PCDE (dB)			Working in-band	≤35
Gain Adjustment Step (dB)			Nominal Output Power -5dB	1dB
Gain Adjustment Range(dB)			Nominal Output Power -5dB	≥30
Gain Adjustable Linear(dB)	10dB		Nominal Output Power -5dB	±1.0
	20dB		Nominal Output Power -5dB	±1.0
	30dB		Nominal Output Power -5dB	±1.5
Inter-modulation Attenuation (dBc)	(GSM/DCS)		Working in-band	≤-45
ACPR(dBc)	±5.0	(WCDMA)	Working in-band	≤-45
	±10.0		Working in-band	≤-50
Spurious Emission(dBm)	9kHz-1GHz		BW:30KHz	≤-36	≤-36
	1GHz-12.75GHz		BW:30KHz	≤-30	≤-30
VSWR			BS/MS Port	1.5
I/O Port			N-Female
Impedance			50ohm
Operating Temperature			-25°C ~+55°C
Relative Humidity			Max. 95%
MTBF			Min. 100000 hours
Power Supply			DC-48V/AC220V(50Hz)/AC110V(60Hz)( ±15%)
Remote Monitoring Function			Real-time alarm for Door Status, Temperature, Power Supply, VSWR, Output Power
Remote Control Module			RS232 or RJ45 + Wireless Modem + Chargeable Li-ion Battery

12 month warranty for repeater equipment ,

6months for accessories of repeater


E-mail:
Products:	UHF Tetra 400MHz Repeater Fiber Optic Signal Amplifier BDA widely used in trunking communication systems
Subject:
Message:
Quantity needed:
Verification: